Power Mode; Temperature Mode - Ellrona Comfort plus2000 SC Mode D'emploi

15.4.3

Power Mode

15.4.4

Temperature Mode

Ellrona Comfort plus 2000 SC
During the cooking process the temperature, power level and
timer can be readjusted as you wish.
When the cooking process is completed turn the
temperature dial to the Standby position (all the way to the left).
The acoustic signal sounds and the appliance is placed in
Standby mode.
• After the device has been turned on with the On/Standby key, it
always operates in the preset power mode.
• Press the Function Key 3. The preset power stage "5" is
selected and the device turns on.
• With the + / - Keys (5+6), you can change the settings at any
time in a range from 1 – 10
When the selection has been made, the indicator in the displays
stops to blink and the power level will be displayed within 5
seconds. If the power level is not displayed, you should select it
via the Function Key 3.
• If the induction cooker detects an excess temperature on the
hob during cooking it displays error message E05. The heating
process is stopped and the device switches to stand-by mode
for 60 seconds.
• The error message will not be cancelled until the temperature
has dropped to below 100° C.
• After turning the device on with the On/Standby key, the
temperature mode can be selected by pressing the Function
Key 2.
• Press the Function Key 2. to select the temperature. The preset
temperature stage "120° C" is selected and the devic e turns on.
• With the + / - keys, you can change the settings at any time in a
range from 60 – 240° C. (Temperature stages: 60, 80 , 100, 120,
140, 160, 180, 200, 220 and 240° C).
• When the selection has been made, the indicator in the displays
stops to blink and the temperature level will be displayed within
5 seconds. If required, another level can be selected anytime.
• If the current temperature is lower than the set level, the cooker
heats up in order to reach the set level. When the temperature
reaches or exceeds the set level, the device adjusts the heat in
order to maintain the set temperature.
Operation and Handling
Please note
56