Timer - Ellrona Ergo 2000 Mode D'emploi

15.4.5

Timer

Ellrona Ergo 2000
In case of "E05" appearing in the display the over heat
protection has been activated.
This means that the temperature had increased to a
temperature of 170° C. In this case the device turns off
automatically in order to avoid damages.
Therefore we recommend to select the function "Stufe" in
case of steaming food or boiling water for example.
In case of grilling or cooking deep fry food we would advise
you to use the function "Temperatur" as in this case you can
use temperatures up to 240° C.
In case of "E05" please pull the power plug in order to reset
the device. After this you can use it again as usual.
• After the selection of the temperature mode press the button
Time 4. until the corresponding control lamps blink. The display
shows the number "0".
• With the arrow keys, you can now select the operating time in
1-minute intervals (up to max. 180 minutes). Once the time is
up, an acoustic signal sounds and the device automatically
goes into standby mode.
• During timer operation, you can change the duration at any time
with the arrow keys. With the memory function of the device, the
power stage or temperature settings remain unchanged here.
• Once the time has been set, it will be displayed within 5
seconds, the indicator stops to blink and the time is counted
down.
• After the set time has elapsed, an acoustic signal is emitted 5
times and the device switches to stand-by mode.
• Should no time be set, the indicator in the display blinks, briefly
shows --- and then turns to previously set mode – either power
or temperature.
• If neither the power mode nor the temperature mode was
selected, the device automatically selects power mode P-5.
• The time or mode, together with the selected conditions, are
alternately displayed every 5 seconds. Otherwise, the device
automatically switches to power mode and displays P-5.
If display shows - - - , please check the pot you use – chapter
"Instructions on cookware").
Operation and Handling
58