EtiamPro HAA80 Mode D'emploi page 4

•
•
•
4. Description
5. Connection Terminals
V. 02 – 10/06/2020
Damage caused by disregard of certain guidelines in this
manual is not covered by the warranty and the dealer will
not accept responsibility for any ensuing defects or
problems.
Nor Velleman nv nor its dealers can be held responsible for
any damage (extraordinary, incidental or indirect) – of any
nature (financial, physical...) arising from the possession,
use or failure of this product.
Keep this manual for future reference.
N.O. contact of the key switch (max. 3 A). Turn the key
1-2
clockwise 90° in order to establish contact.
Green LED with an internal resistor of 1 kΩ, connected
3-8 in series. Connect the positive (+) power supply of
12 VDC with 3 and the ground connection (-) with 8.
Red LED with an internal resistor of 1 kΩ, connected in
4-7 series. Connect the positive (+) power supply of
12 VDC with 4 and the ground connection (-) with 7.
The N.C. contact of the anti-tamper switch (max. 0.5 A)
is closed when the housing is closed. Slide the flexible
5-6 sleeve (included) over the lever of the anti-tamper
switch, ensuring that the latter is pressed down when
the housing is closed.
A
B
C
D
E
F
G
H
I
J
K
HAA80
green
red
tamper switch
key switch
5-core wire
alarm control panel
ON/OFF control
+12V supply
tamper
red LED (-)
green LED (-)
4 ©Velleman nv