Pushing The Appliance Into The Installation Cavity - Bosch B36IT71SNS Instructions D'installation

9.

Pushing the appliance into the installation cavity

m
CAUTION
Caution when pushing the appliance into the installation
cavity.
– Do not damage the water pipe or power cord
attached to the floor.
– Check finger guard on both sides when pushing the
appliance into the cavity. Immediately after pushing
the appliance into the cavity, check that it functions
by opening and closing the doors.
NOTE
When the floor or the appliance is tilted in comparison
to the installation cavity adjust height adjustable wheels
before you move the appliance into the installation
cavity.
Put the mains plug into the socket.
Prevent the power cord from becoming caught.
Tie a piece of string to the middle of the power cord and
feed forwards under the appliance. When pushing in the
appliance, pull the cable forwards.
or
Using adhesive tape, stick the power cord to the floor
centrally behind the appliance approx. 15" (380 mm)
away from the rear panel of the cavity.
16
Carefully push the appliance into the cavity. Insert
m
appliance straight! Push in the appliance until the frame
is situated on the cavity walls.
Remove the edge protection.
Remove transportation protection device from the
underside of the freezer compartment drawer.
Check function of the finger guard.
Open and close both doors of the refrigerator
compartment. The finger guard must slide smoothly in
the gap between the appliance and cavity wall.