SPORT-ELEC HC-5339 Notice D'emploi page 4

INSTRUCTION MANUAL
IMPORTANT SAFETY INSTRUCTIONS
- It is recommended to use the appliance on a electrical
installation using a differential with nominal current loss which does-
n't exceeds 30m A.
- If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person
in order to avoid a hazard.
- Do not reach for an appliance that has fallen into water. Unplug it
immediately.
- Do not use while bathing or showering.
- Do not place or store appliance where it can fall or be pulled
into a tub or sink.
- Do not place in or drop into water or other liquid.
- You can fixe the parts only if they cannot drop into
water.
- Do not attempt to plug or unplug unit while feet are in the water.
- An appliance should never be left unattended when plugged in.
Unplug from outlet when not in use and before putting on or taking
off parts or attachments.
- Close supervision is necessary when this appliance is used by,
on, or near children, invalids or disabled persons.
- Use this appliance only for its intended use as described in this
manual. Do not use attachments not recommended by the supplier;
specifically any attachments not provided with the unit.
- Never operate this appliance if it has a damaged cord or plug,
if it is not working properly, if it has been dropped or damaged,
or dropped into water. Return it to appropriated service center for
examination and repair.
- This appliance is designed for household use only.
- The supply cord cannot be replaced. If the cord is damaged the
appliance should be scrapped.
SAVE THESE INSTRUCTIONS
Specifications
Charging unit: AC 230V,AC (~) 50/60 Hz. 2,5 W.
Rechargeable power unit: Battery:Ni-MH 1/2AA 300mAh 2.4V,
max. operation time approx. 20/25 min. when fully charged.
Notice: when the rechargeable cells are running empty the plaque
remover automatically turns off.
Connecting
The charging unit can be connected to any voltage outlet -even
to shaver sockets- between 120- 240 volts AC (-).
Place the rechargeable power unit, facing the front onto the
charging base.
The red indicator will light up when the toothbrush is inserted on
the plugged in charging base.
The toothbrush may warm up somewhat during recharging. This has
no significance on the unit's operation. Over-charging is impossible.
To maintain the toothbrush's full performance, it should
always be stored on the charging base after use.
Preserving the rechargeable batteries
To maximize the capacity and life of the rechargeable batteries, they
should be fully charged for 16 hours before the first use and then fully
discharged by using Then recharge to full capacity again
This discharging/charging procedure should be done every six months.
How to use
- Before using your Plaque Remover for the first time, charge the
power unit at least 16 hours
- After the power unit has been fully charged, attach the attach-
able brush head to the power unit.
- Before doing so, you may fix one of the brush head onto the end
of the brush head.
- The brush head must face the same direction as the switch.
- Before brushing your teeth, rinse your mouth thoroughly and wet
the brush head.
- You may use regular toothpaste. To avoid splashing, switch the
power unit on after guiding the brush head to your teeth. Then
move the brush head along the chewing surfaces of your teeth.
- Guide it along the outsides and then the insides of your teeth.
Be sure to get into the spaces between your teeth as well as
along the gum line
- You do not need to press hard To thoroughly remove plaque, brush
for at least 2 minutes.
- After cleaning your teeth, rinse your mouth thoroughly again.
During the first few days of using, your gums may bleed slightly,
particularly if they normally tend to do so. After a few days, the
bleeding will generally stop. If your gums continue to bleed after
2 weeks, you should see your dentist.
- Clinical tests have shown that the best cleaning effect is achieved
by gently moving the brush from tooth to tooth, without exerting
pressure
- A change in the shape of the brush is normal after use. This is
influenced by your individual cleaning technique, but does not affect
the efficiency of the brush.
7
WARNING
Do not use your device in a damp atmosphere (sauna) or close
to an electrical appliance connected to the mains and the ground,
or even piping connected to the ground.
Cleaning
To maintain the function of the brush head, rinse thoroughly for
several seconds with the power unit switched on under running
water after use. Clean the brush head and the power unit by
simply holding them under running water. Wipe the power unit
dry. After cleaning place the power unit back on the charging base.
Additionally, we recommend soaking the brush head in a denture
cleaner (commercially available) every 2 to 4 weeks to keep it
hygienically clean.
Protecting the environment
-Remove the built-in rechargeable battery when eventually
discarding your appliance.
-You can also take the appliance to a Service Centre, The staff will
be happy to help you.
-Before removing, the battery should be completely empty of
charge, Let the appliance run until the motor stops,
-Only unscrew the bottom for battery removal. The toothbrush
may not be watertight anymore after the bottom has been
unscrewed,
-This product contains NiMH cells. In the interest of
protecting the environment, please do not dispose of the product
in the household waste at the end of its useful life. Disposal can
take place at a Service Centre or at appropriate collection sites
provided in your country.
Recommendations: When disposing of your product at end of life
cycle, please comply with national regulations. Please dispose
the device in allocation provided for this purpose in order to
ensure safe and environmentally-friendly
Norms :
CE : -(2004/108/CE/EMC)
-(2006/95/CE/LVD)
RoHS (2002/95/EC) : The product is made with friendly
environmentally materials.
USA
destruction.
8
USA