Domo DO9134WK Mode D'emploi page 37

www.domo-elektro.be
PARTS
1. Spout with removable filter
2. Lid
3. Button to open the lid
4. Handle
5. Water level indication
6. On/off switch with
indicator light
7. Base
1
BEFORE THE FIRST USE
Boil a full water kettle and pour away the water. Repeat this twice before actually
using the water kettle for the first time.
USING THE WATER KETTLE
1. Place the water kettle on a flat and stable surface.
2. Remove the water kettle from its base and open the lid by pressing the top button.
3. Fill the water kettle with the desired amount of water. Make sure that the water
level is always higher than the minimum indication (0.5 l) and lower than the
maximum indication (1.7 l).
• If you have not added enough water, the water kettle will switch off
before the water boils.
• If you have added too much water, the boiling water could escape
through the spout. That is why you should never exceed the
maximum indication when filling the kettle. Also, always make sure
that the lid is properly closed before turning on the watter kettle.
4. Close the lid. Make sure that it is closed well.
5. Place the water kettle on its base.
6. Plug in the appliance.
7. Press the on/off switch at the bottom of the handle. The indicator will light up and
the water kettle will start the boiling process.
8. The water kettle will automatically switch off when the water boils. You can
always stop the boiling process yourself at any moment by pushing the on/off
switch upward.
2 3
37
DO9134WK
4
5
6
7
3
6