AEG FAVORIT 65060 VI1P Notice D'utilisation page 26

26 www.aeg.com
Electronic adjustment
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
2. Press and hold, at the same time,
Program and ExtraHygiene until the
indicators of Delay, Program and Ex-
traHygiene start to flash.
3. Press Delay.
• The indicators of Program and Ex-
traHygiene go off.
• The indicator of Delay continues to
flash.
6.2 Filling the salt container
6.3 Filling the rinse aid dispenser
A B
A
+ -
C
D
• The acoustic signals operate. E.g.
five intermittent acoustic signals =
level 5.
• The display shows the setting of
the water softener. E.g.
5.
4. Press Delay again and again to
change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
1. Turn the cap counterclockwise and
open the salt container.
2.
Put 1 litre of water in the salt con-
tainer (only for the first time).
3. Fill the salt container with dishwash-
er salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between
position 1 (lowest quantity) and
position 4 (highest quantity).
= level