Kenwood KDC-BT358U Mode D'emploi page 11

The connectivity result (OK or NG) appears after the test.
PAIRING: Pairing status
HF CNT: Hands-Free Profile (HFP) compatibility
AUD CNT: Advanced Audio Distribution Profile (A2DP) compatibility
PB DL: Phonebook Access profile (PBAP) compatibility
• To cancel check mode, press and hold B SRC to turn off the unit.
Bluetooth mobile phone
To Do this
Receive a call
Press
the number buttons (1 to 6) (or press
on RC-406).
• All the button illumination flash when
there is an incoming call.
• When [AUTO ANSWER] is set to the
selected time, the unit answers
incoming call automatically. ( 11)
Press B SRC (or press
Reject an incoming
call
End a call
Press
RC-406).
Switch between Press 6 IW during a call.
hands-free and
• Operations may vary according to the
private talk modes
connected Bluetooth device.
Adjust the phone Turn the volume knob during a call.
volume
Phone volume: [00] to [35] (Default: [15])
• This adjustment will not affect the
volume of the other sources.
Switch between two
Press
connected phones
• Not applicable during a call.
or the volume knob or one of
on RC-406).
or B SRC (or press
on
repeatedly.
Improve the sound quality during a call
While talking on the phone...
1 Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to make a selection (see the following table),
then press the knob.
3
Press and hold to exit.
To return to the previous setting item or hierarchy, press
MIC GAIN –20 — +8 (0): The sensitivity of the microphone increases as the number
increased.
NR LEVEL –5 — –20 (–10): Adjust the noise reduction level until the least noise is
being heard during a phone conversation.
ECHO CANCEL 1 — 10 (4): Adjust the echo cancellation delay time until the least echo is
being heard during a phone conversation.
Text message notification
When the phone receives a text message, the unit rings and "SMS RECEIVED"
appears.
• You cannot read, edit, or send a message through the unit.
• To clear the message, press any button.
Use Voice Recognition
1 Press and hold to activate Voice Recognition.
The connected phone (which has been paired the earliest) is activated.
However, if priority device is connected, pressing and holding
the priority device. ( 13, DVC PRIORITY)
2
Speak the name of the contact you want to call or the voice command
to control the phone functions.
• Supported Voice Recognition features vary for each phone. Refer to the
instruction manual of the connected phone for details.
• This unit also supports the intelligent personal assistant function of iPhone.
BLUETOOTH®
.
Default: XX
activate
ENGLISH | 11