Accessories - Crosley W10096992A Guide D'utilisation Et D'entretien

TROUBLESHOOTING cont.
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
If you experience
Cycle time too short
Lint on load
Stains on load or drum
Loads are wrinkled
Odors
Load is too hot

ACCESSORIES

Enhance your dryer with these premium accessories.
For more high-quality items or to order, call 1-800-901-2042,
or visit us at www.applianceaccessories.com. In Canada,
call 1-800-807-6777 or visit us at www.whirlpoolparts.ca.
Part Number
3404351 Drying rack – fits 29" (737 mm) Super
Capacity, 6.5 cu. ft. (0.18 cu. m) –
side swing or hamper door
3406839 Drying rack – fits 29" (737 mm) Super
Capacity Plus, 7.0 cu. ft. (0.20 cu. m) –
side swing door only
12
to possibly avoid the cost of a service call.
Possible Causes
Sensor cycle ending early.
Lint screen clogged.
Dryer fabric softener not properly
used.
Load not removed from dryer at the
end of the cycle.
Dryer tightly packed.
You have recently been painting,
staining, or varnishing in the area
where your dryer is located.
The electric dryer is being used for
the first time.
Laundry items were removed from
the dryer before the end of the
cycle.
A high temperature cycle was used
or TEMPERATURE control was set
to high.
Accessory
The load may not be contacting the sensor strips. Level the
dryer.
Use Timed Dry for very small loads. Change the Dry Level
setting on Sensor Dry/Auto Dry cycles.
Increasing or decreasing the Dry Level setting will change the
amount of drying time in a cycle.
Lint screen should be cleaned before each load.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Select Wrinkle Prevent feature to tumble the load without heat
to avoid wrinkling.
Dry smaller loads that can tumble freely to reduce the chance
of wrinkles forming.
Ventilate the area. When the odors or fumes are gone from the
area, rewash and dry the clothing.
The new electric heating element may have an odor. The odor
will be gone after the first cycle.
Allow Cool Down cycle to finish before removing laundry from
dryer. All cycles are cooled slowly to reduced wrinkling and
make it easier to handle. Items removed before Cool Down may
feel very warm.
Select a lower temperature, and use a Sensor Dry/Auto Dry
cycle. These cycles sense the temperature or the moisture level
in the load and shut off when the load reaches the selected
dryness. This reduces overdrying.
Solution