Nohrd Bike Notice De Montage page 29

Service / Parts: www.nohrd.com
Step 1
Lay the bike's solid wood main frame piece (A) on the empty packaging,
as shown, with the resistance dial facing upward. Be careful not to scratch
or scuff.
Place the right foot stand (D) onto the main frame piece so that the
pre-assembled wheel is facing forward. Guide the 2x threaded rods (N)
through the upper holes. Now take the left foot stand (C) and hold it to the
main frame piece at the bottom to attach with the included sleeve nuts (N).
Please use the included 6mm allen key (S), and tighten the screws – not all
the way.
Step 2
Insert the 2x cylinder screws M10x100 (M) through the rest of the holes in
the right foot stand (D). Screw the cylinder screws M10x100 (M) tight
enough, so that they reach into the pre-drilled screw threads on the left
foot stand (C).
Now tighten all screws (2x cylinder screws M10x100 and 2x threaded rods
with sleeve nuts) firmly.
Please note: The feet can be adjusted to the floor with the included spanner
SW17 (V).
29