Publicité
Les langues disponibles
Les langues disponibles
Anleitung PS-AS 14,4_SPK1
GB
Troubleshooting
Problem
Possible cause
1. The electric tool will not work
1. The battery pack is not fitted
despite the battery pack being in
correctly
place.
2. The battery pack is not charged
or defective.
2. The red charging control light is
1. The mains plug for the charger
not lit when the battery pack is
is not connected to the supply.
fitted.
2. The charger's mains cable is
defective.
3. The battery pack is fully
charged.
3. The electric tool works but the
The drill or screwdriver bit is loose
drill bit or screwdriver bit does not
turn.
4. The electric tool works and the
The electric tool is set to turn
drill or screwdriver bit turns but it
counter-clockwise.
does not produce a hole or does
not tighten the screw.
5. As you are drilling or tighten the
1. The battery pack is discharged.
screw, the electric tool suddenly
2. The screw is fully tightened or
cuts out.
blocked.
3. The drill bit is blocked.
Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of tool
Article number of the tool
ID number of the tool
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
10
20.08.2005
9:13 Uhr
Seite 10
Solution
1. Check that the battery pack is
fully fitted in the tool and is held
securely by the fixing attachments.
2. Charge the battery pack. If the
electric tool still fails to work after
you have charged the battery,
have the battery pack and tool
checked by a specialist workshop.
1. Connect the plug to the socket.
2. Have the cable repaired by a
specialist workshop.
3. Remove the battery pack.
Tighten the chuck.
Switch the direction to clockwise.
1. See problem 1.
2. Switch off the electric tool or
3. Switch the electric tool to turn
counter-clockwise to release the
blocked screw or drill bit.
Publicité
