Internet Setup; Displaying Updated Information And; Support Service - Sharp Aquos LC-46LE540U Mode D'emploi

Using the Internet

Internet Setup

Example
Menu
Initial
Setup
Initial Setup
EZ Setup
Broadcasting Setup
Internet Setup
Language
[English]
Individual Setup
Reset
DivX ® Setup
Connection Type
1
Press MENU to display the MENU screen, and then
c / d
press to select "Initial Setup".
2
Press a / b to select "Internet Setup", and then
press ENTER.
3
Press a / b to select ''Network Setup'',and then press
ENTER if ''Interactive Service'' is selected ''YES''.
4
c / d
Press to select ''Wired'' or ''Wireless'' at
''Connection Type''.
Wireless Setup
If your access point supports Wi-Fi Protected Setup
(WPS), it is recommended that you use this function
for the wireless connection. You can press the WPS
button on the access point to confi gure the settings
automatically.
• The name of the WPS button function may differ depending
on the access point. See the operation manual of the
access point for details.
1
Confi rm the current settings in "Interface".
Ethernet
• If " " is selected, press c / d to select "Wireless".
2
Press a / b to select "Wireless Setup", and then
press ENTER.
• Confi rm the settings. If each setting item is correct,
press MENU to exit.
• If you are confi guring the wireless setup for the fi rst
time or changing the settings, go to step 3.
Interactive Service
If you do not want other people to connect to the
Internet in your absence, you can make settings to
keep the TV away from the Internet.
1
Press MENU to display the MENU screen, and then
press c / d to select "Initial Setup".
2
Press a / b to select "Internet Setup", and then
press ENTER.
3
Press a / b to select "Interactive Service".
4
Press c / d to select "No", and then press ENTER.
• If you want to allow Internet connection, select "Yes",
ENTER
and then press
5
Press MENU to exit.
.
If you cannot connect to the Internet
Perform the procedures below to check your TV's
network settings.
IP Setup
1
Press EXIT to display the normal TV screen.
2
Press MENU to display the MENU screen, and then
press c / d to select "Initial Setup".
3
Press a / b to select "Internet Setup", and then
press ENTER.
4
Press a / b to select "Network Setup", and then
press ENTER .
• Check that numbers are displayed for each setting.
• If there are any settings without numbers, specify the
numbers by following the on-screen instructions.
• For information on how to enter text, see page 52.
Example
Setting information
[Current setup]
IP Address
Netmask
Gateway
DNS
Wireless MAC : 12:34:56:78:9A:BC
5
Press MENU to exit.

Displaying Updated Information and

Support Service

This function can be used to display up-to-date
information on the original home page and allow you to
receive support service over the network.
: Auto setup
: Auto setup
: Auto setup
: Auto setup
Change
51