Technical Description; Information On The Electrical Connections - Dometic PERFECTVIEW CAM60ADR Instructions De Montage Et De Service

CAM60ADR
6

Technical description

The camera with integrated microphone, which is encased in aluminium housing, transmits image
and sound to a monitor via a cable. The infrared LEDs improve night vision.
The camera transmits the image as if you are looking in the rear mirror.
The camera consists of the following main elements:
No. in
fig. 7,
Description
page 5
1 6-pin connection cable
2 Infrared LEDs
3 Microphone
7

Information on the electrical connections

7.1 Laying cables
A
NOTICE! Risk of damage!
• To prevent damage, when drilling ensure that there is sufficient space on the other
side for the drill head to come out.
• Cables and connections which are not properly installed will cause malfunctions or
damage to components. Correct installation of cables and connections is the basic
prerequisite for lasting and trouble-free operation of the retrofitted components.
• The cables may not be exposed for long periods to solvents such as benzine, as the
solvents can damage the cable.
Please observe the following instructions:
• As far as possible, use original openings or alternative openings for the connecting cable duct,
e.g. the paneling edges, ventilation grilles or blank panels. If no openings are available, you
must drill holes for the cables. Check beforehand that there is sufficient room for the drill head
to come out on the other side.
• Wherever possible lay cables inside the vehicle, as they are better protected inside than outside
the vehicle.
If you do need to lay a cable outside the vehicle, ensure that it is well secured (use additional
cable ties, insulating tape, etc.).
• To prevent damage to the cables, when laying them ensure that there is sufficient distance to
hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans, heater,
etc.). Use corrugated piping or other protective materials to protect against mechanical wear.
• Screw on the plug connections of the connecting cables to protect against water penetration
(fig. e, page 7).
EN
Technical description
13