Technical Description; Information On Electrical Connection - Dometic CAM45 Mode D'emploi

CAM45
5

Technical description

The camera with integrated microphone, which is encased in an aluminium housing, transmits
image and sound to a monitor via a cable. The infrared LEDs improve night vision.
The camera transmits the image as if you were looking in the rear-view mirror.
The camera consists of the following elements:
No. in
fig. 9, page 5
1
2
3
6

Information on electrical connection

6.1 Laying cables
A
NOTICE! Beware of damage
•
When drilling holes, check beforehand that there is sufficient space on the other
side for the drill head to come out.
•
Cables and connections that are not properly installed will cause malfunctions or
damage to components. Correct installation of cables and connections ensures
lasting and trouble-free operation of the retrofitted components.
•
The cables may not be exposed for long periods to solvents such as benzene, since
solvents can damage the cable.
Therefore, please observe the following instructions:
•
As far as possible, use original ducts for laying the cables, or other suitable options such as
panelling edges, ventilation grilles or dummy plugs. If no openings are available, you must drill
holes for the cables. Check beforehand that there is sufficient space on the other side for the
drill head to emerge.
•
Wherever possible, lay cables inside the vehicle, as they are better protected there than
outside.
If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use additional
cable ties, insulating tape etc.).
•
To prevent damage to the cables when laying them, ensure that they are far enough away from
hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans, heaters,
etc.). Use corrugated piping or other protective materials to protect against mechanical wear.
•
Screw on the plug connections for the connecting cables to protect them against water
penetration (fig. g, page 7).
EN
Description
6-pin connection cable
Infrared LEDs
Microphone (rear side)
Technical description
13