Operation Instructions - Danby DDR30B2GDB Guide D'utilisation

CONTROL PANEL
INSTRUCTIONS
(2) Reset filter
button
(1) Continuous
mode
Continuous
mode indicator
CONTROLS
When you push the button to change operation modes, the unit will make a beeping sound to indicate that it is
changing modes.
1) CONTINUE BUTTON
Press to activate the continuous dehumidifying operation.
Refer to page 7.
2) FILTER BUTTON
This product has a check lter feature that is a reminder to
clean the air lter for more ef cient operation. The check
lter light will illuminate after 250 hours of operation. To
reset this function after cleaning the lter, press the reset
lter button and the light will go off.
3) FAN BUTTON
Controls the fan speed. Press to select either High (Turbo)
or Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set the
fan control back to Normal.
4) POWER BUTTON
Press to turn the dehumidi er on or off.

OPERATION INSTRUCTIONS

NOTE: The control panel of the unit you purchased may be slightly different
depending on the model number.
Check filter
light
Auto on
Timer button
indicator
light
(7)Display
Bucket full
Auto off
(6)
indicator light
(5)
Up and
down
buttons
5) ( + / - ) BUTTONS
The humidity level can be set within a range of
35% RH (Relative Humidity) to 85% RH in 5% increments
using these buttons.
• For drier air, press the (-) button and set to a lower
percentage value (%)
• For more damp air, press the (+) button and set a higher
percentage value (%)
6) TIMER BUTTON
Press to initiate the auto-start and auto-stop feature. Set a
start or stop time from 0.0 to 24 hours using the (+) and (-)
keys. Refer to page 6.
7) DISPLAY
Shows the actual (± 5% accuracy) room humidity level
in a range of 30% RH to 90% RH. Otherwise, displays
selection when programming humidity or timer.
5
Turbo fan speed
indicator
(3) Fan button
Normal fan speed
indicator
(4) Power button
Auto defrost