Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
POWERVENT
The POWERVENT centrifugal range of in-line duct exhaust fans have been manufactured to the
rigorous standards of production as defined by the International Quality Standards ISO 9001. All
the components have been checked and tested at the end of the manufacturing process.
We recommend that you check the following after receiving this product:
1.
The correct size has been received
2.
The correct model has been received
3.
The details on the rating label correspond to the electrical supply: voltage frequency etc.
Remove the unit from packaging and inspect for shipping damage within 15 days of receipt. If the
product is found to be damaged, immediately contact your local authorized supplier. DO NOT OPE-
RATE THE UNIT IF DAMAGED.
These instructions should be considered as a supplement to all applicable EPA standard practices,
state and local building code regulations.
ENVIRONMENT
The POWERVENT series of fans are suitable for operation in indoor environments only. All models
are suitable for the exhaust and supply of non-hazardous airstreams.
INSTALLATION
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY, OBSERVE THE
FOLLOWING:
(a) Use this unit only in the manner intended by the manufacturer. If you have any questions
contact the manufacturer.
(b) Before servicing or cleaning the unit, switch the power off at the service panel and lock the
service disconnecting means to prevent power from being switched on accidentally. When
the service disconnecting means cannot be locked; securely fasten a prominent warning
device such as a tag to the service panel.
(c) Installation work and electrical wiring must be done by qualified person(s) in accordance with
all applicable codes & standards including fire rated construction.
(d) Sufficient air is needed for proper combustion and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment
manufacturers guideline and safety standards such as those published by the National Fire
Protection Association (NFPA) and the American Society For Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE) and the local code authorities.
(e) When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden
utilities.
(f) Ducted fans must always be vented to the outdoors.
(g) If this unit is to be installed over a tub or a shower, it must be marked as appropriate for the
application and connected to a GFCI (Ground Fault Circuit Interrupter) – protected branch
circuit.
(h) Never place a switch where it can be reached from a tub or shower.
4
Publicité
