Kenwood KS-708HT Mode D'emploi page 5

Connections
The speaker wires and labels of speakers' back panel are color-coded to facilitate connection. Connect each wire to the matching-
colored terminal, as shown in the figure.
Be sure to turn off your amplifier before connecting or disconnecting speakers.
1. Twist wire's
conductor
Subwoofer (option)
SPEAKERS (6-8Ω)
FRONT CENTER SURR BACK
SUB
WOOFER
1. The speaker system's maximum input power is indicated in the specifications. To avoid speaker damage, never run the
speakers at power levels exceeding this limit.
2. This speaker system has a nominal impedance of 8 ohms. To ensure safe and reliable operation, be sure that your
amplifier or receiver is able to work with 8-ohm speakers.
• Never short the (+) and (–) speaker wires together.
• Do not reverse L and R or (+) and (–) connections. Reversal of sides or polarities may result in unnatural, incorrectly positioned
sound.
2. Push
Right
(–)
Wire with white line
SURR
/SW
Speaker terminals
(Amplifier or receiver)
3. Insert the
conductor
Front speakers
Center speaker
(+) Red
(–) (+) Green
Right
Surround
speakers
(–)
(+)
Gray
4. Release
➤
Left
(–)
Left
Blue
(–)
(+)
White
(+)
5
EN