Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
Read this manual carefully before using the
machine, for your own safety.
SAFETY INSTRUCTIONS
When using the machine, always observe the
enclosed safety instructions as well as the
additional safety instructions.
The following symbols are used throughout this
manual:
Denotes risk of personal
injury or damage to the
You will find the following symbols on the
machine:
Laser beam warning
Laser beam characteristics
ADDITIONAL SAFETY INSTRUCTIONS FOR
DRILL PRESSES
Only connect the machine to an earthed
mains supply.
Only use tree-core extension cords.
Always wear safety goggles, and a hairnet
for long hair.
Do not wear gloves, ties or loose clothing.
While drilling, never hold the workpiece by
hand, but firmly tighten it to the drilling table
using a vice e.g. Never keep your fingers on a
place where they could touch the drill in case
the workpiece should move unexpectedly.
Do not use the machine until it has been
mounted and installed completely according to
the instructions.
Do not switch on the machine while moving
the head relative to the table or vice versa. Do
GB - DRILL PRESS
tool.
14
not switch on the machine until having checked
that head and table have been tightened firmly
to the pillar.
Do not use the machine if a part is damaged
or badly functioning.
Adjust the table or depth stop to prevent the
drill from entering the table. Do not perform any
design, assembly or construction activities on
the table while the machine is switched on.
Make sure that the chuck key (if applicable)
has been removed before switching on the
machine.
Before switching on the machine, make sure
the chuck has been mounted correctly, the drill
has been mounted into the chuck firmly and the
safety guard has been shut.
In operation, use the recommended speed
for the drilling accessories and the material.
Switch off the power, remove the drill and
clean the table before leaving the machine.
Lock the on/off switch when leaving the
machine.
ADDITIONAL SAFETY INSTRUCTIONS FOR
LASERS
Warning! The laser beam potentially causes
severe eye damage. Never look or stare
directly into the laser beam.
During use, do not point the laser beam at
people, directly or indirectly through reflecting
surfaces.
This laser complies with class 2 according to
EN 60825-1/A11, 1996. The unit includes no
servicing components. Do not open the
housing for any reason. If the unit is damaged,
have the damage repaired by an authorized
repair agent.
ELECTRICAL SAFETY
Always check that the
power supply corresponds
to the voltage on the rating
plate.
Publicité
Table des Matières
