Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Procedure:
Step 1: Unscrew the fixation-screws of the housing-ball.
Step 2: Remove the front housing-cover.
Step 3: If replacing the lamp, remove the old lamp from the lamp-socket.
Step 4: Put the new 230 V/15 W E-14 lamp into the lamp-socket.
Step 5: Replace the housing-cover and tighten the screws.
OPERATION
Install the device on a plane surface. Connect the fixture to the mains with the power-plug. With the
POWER-switch, you can switch the device on and off.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the lamps. Maintenance and service operations
are only to be carried out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
Rotation-speed:
Around main axle:
Around ball-axle:
Maximum ambient temperature T
Maximum housing temperature T
Min. distance from flammable surfaces:
Min. distance to lighted object:
Dimensions (LxWxH):
Weight:
Fitting lamp:
OMNILUX T20 230V/15W E-14
Please note: Every information is subject to change without prior notice. 25.05.2009 ©
Do not operate this device with opened housing-balls!
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
:
a
(steady state):
B
230 V AC, 50 Hz ~
35 W
approx. 16 RPM
approx. 43 RPM
25° C
60° C
0.5 m
0.5 m
230 x 180 x 200 mm
0.8 kg
No.:
92004630
11/21
00047010.DOC, Version 1.0
Publicité
Table des Matières
