Standby Mode - CDVI SOLARKPW Manuel D'installation

MANUEL D'INSTALLATION
SOLARKPW-SOLARKPB
Dual Technology Digicode
Code Length
- The user code must be in 4, 5, 6, 7 or 8 digits,
- In direct mode, all the keypad keys can be
used to program a user code except the B key,
- In hexadecimal mode, all the keypad keys
can be used to program a user code
except the A and B key,
- Enter the user code and then B to validate
the code.
Programming
for decimal or
hexadecimal mode
A5
1 beep
Green LED ON
Enter:
- 0 = disable the
keypad beeps
- 1 = Enable the
keypad beeps
1 beep = OK
Green LED ON
4 beeps = Error
B
Stand-by mode:
In stand-by mode, the keypas is weakly illuminated
and the reader is OFF. Approaching activate the
system, the keypad illumination becomes more
intense (starting of the time-out) and the reader
reverts in ON. The reader come back on stand-by
mode at the end of the time-out.
/Proximity reader - Wiegand
®
Programming
the audible signal
A6
1 beep
Green LED ON
Enter:
Enter the 5 terms
of the master code
1 beep = OK
Green LED ON
4 beeps = Error
B
Enter the master code
2 times
2 beeps are emitted
Red
LED ON
Programmation
du mode de
fonctionnement
1 beep
Green LED ON
Tapez :
- 0 = Permanent
- 1 = Stand-by
1 bip = OK
LED verte ON
(4 bips = Erreur)
B
2 beeps are emitted
cdvigroup.com
EN
A7
B
cdvi.com
17