ASSEMBLY
WARNING
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this blower.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
OPERATION
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING
Verify that all guards and tubes are in place prior to use.
If the blower is dropped, stop blower and verify that
no damage has occurred. If any guard, part, or tube is
damaged or missing, do not use blower until it has been
repaired or replaced by a qualified service center. Use of
blower with damaged or missing guards, parts, or tubes
can result in serious personal injury or further damage
to the blower.
WARNING
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from
the tool when assembling parts.
Assembling the Blower Tube
See Figure 2.
Align raised tabs on blower housing outlet to the slots
on blower tube; slide together and tighten securely by
twisting. Check tightness after initial use and retighten if
needed.
NOTE: When tightening, ensure the blower tube's locking
rib slides over the raised tabs of the blower housing outlet.
To remove, rotate the tube to unlock it and remove from
the blower housing outlet.
NOTICE
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a
qualified service center for assistance.
Applications
You may use this product for the purposes listed below:
Clearing leaves and other debris from your lawn
Keeping decks and driveways free from grass clippings,
leaves, pine needles, and other debris
This product will accept ECHO 58V lithium-ion battery
packs only.
For complete charging instructions, refer to the Operator's
Manuals for your ECHO battery pack and charger models.
To Install/Remove Battery Pack
See Figure 3.
WARNING
Always remove battery pack from your tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
English
7