Rotel U1121CH Mode D'emploi page 12

 INSTRUCTION MANUAL
 ELECTRICAL CONNECTION
o
The hot plates must be connected to a socket that has been installed correctly and
earthed. The socket must have a 10 amp fuse. The power cable must not hang
down or come into contact with the hot plates. Power cables of other electrical
appliances must also not come into contact with the cooking plates.
 BEFORE STARTING THE APPLIANCE
o
Only place the appliance on level, heat resistant surfaces.
o
Before using the hot plates for the first time, turn the hobs on to maximum for
about 5 minutes without placing a pan on the top, so that the protective layer can
burn off. This protects the hob against rust. Ventilate the room well when you do
this. The smoke that comes off is completely normal and will not happen again in
normal use.
o
The bottom of any pots and pans you use must be clean and dry.
 HOW TO USE THE SETTINGS
o
The hot plates are switched on and controlled using the thermostat knob. First
place the pan on the hot plate and then switch it on. To cook the contents quickly
adjust the knob to the highest setting. When you reach boiling point, turn the knob
back down to a lower setting. After you have finished, pull the plug out.
 PANS AND COOKWARE
o
Only use cookware that has a flat bottom and with a width that will fit on the hot
plate. If the pan is too wide or uneven, it will take longer to cook the contents and
use more electricity. Always choose pans that are big enough to cover the hot plate
so nothing can spill out and get stuck to it.
 CLEANING AND CARE
o
Before cleaning the hot plates always pull the plug out and let the appliance cool
down. Never immerse the appliance in water!
o
Wipe up any food that has spilled out with a damp cloth and some washing up
liquid.
o
Never use any abrasive cleaning agents or scouring pads.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use