emerio DH-124928.1 Mode D'emploi page 11

CLEANING AND MAINTENANCE
The appliance must be regularly cleaned to prolong its life and keep it functioning properly.
Warning: Before performing any cleaning, turn off the unit and unplug it to avoid electrical shocks. Do not use
hot water or chemical solvents for cleaning.
1. Regularly, clean the water tank with cold or warm water and dry with a soft cloth to avoid any mildew.
2. Clean the surface of the appliance using a moist cloth. Do not use detergents or abrasive sponges that can
cause damage to the plastic surface.
3. Clean the filter as described in the following section.
4. When the unit will not be used for a long time:
Empty and dry the water tank, and then install it back.
1)
Clean the filter.
2)
Place the appliance upright and avoid the direct sunlight.
3)
Filter
There is a filter net inside the appliance that must be removed and cleaned regularly. The dehumidity capacity
may reduce when the filter net is clogged with defilement.
• Remove the filter net, detach the net (A) and filter case (C) to take out the activated carbon layer (B).
• The net and filter case can be washed in water (temperature < 40°C). Dry well before installation.
• The activated carbon layer cannot be cleaned in water. You may use a vacuum cleaner to remove the dust.
It is recommended that the activated carbon layer (B) be replaced every 3-6 months (depending on usage) to
ensure peak performance of the appliance.
TROUBLE SHOOTING
Problem
No working
Possible Cause
Whether the power plug is connected Plug in
Whether the water tank is full
Whether the water tank is in position Place it well
Whether the air outlet cover is open
Is the filter clogged?
Solution
Empty the water tank
Open the air outlet cover
Clean the filter
- 10 -