ASROCK K10N78hSLI-GLAN Mode D'emploi page 25

1. If you plan to use RAID 0, RAID 1 or JBOD function, you need to install at
least 2 SATA / SATAII hard disks. If you plan to use RAID 5 function, you
need to install 3 SATA / SATAII hard disks. If you plan to use RAID 0+1
function, you need to install 4 SATA / SATAII hard disks.
2. It is recommended to build RAID on internal SATAII ports. In other
words, if SATAII_6 (PORT5) is used for eSATAII port, please build
RAID on other SATAII ports.
3. Under non-RAID mode, SATAII_5 (PORT4) and SATAII_6 (PORT5)
cannot function.
2.11 Hot Plug and Hot Swap F 2.11 Hot Plug and Hot Swap F 2.11 Hot Plug and Hot Swap Functions for SA 2.11 Hot Plug and Hot Swap F 2.11 Hot Plug and Hot Swap F
HDDs and eSA HDDs and eSAT T T T T AII Devices HDDs and eSA
HDDs and eSA HDDs and eSA
This motherboard supports Hot Plug and Hot Swap functions for SATA / SATAII / eSATAII
Devices in RAID / AHCI mode. NVIDIA
support for Advanced Host controller Interface (AHCI), a new programming interface for
SATA host controllers developed thru a joint industry effort. AHCI also provides usability
enhancements such as Hot Plug.
NOTE
What is Hot Plug Function?
If the SATA / SATAII HDDs are NOT set for RAID configuration, it is called
"Hot Plug" for the action to insert and remove the SATA / SATAII HDDs
while the system is still power-on and in working condition.
However, please note that it cannot perform Hot Plug if the OS has been
installed into the SATA / SATAII HDD.
What is Hot Swap Function?
If SATA / SATAII HDDs are built as RAID1 or RAID 5 then it is called "Hot
Swap" for the action to insert and remove the SATA / SATAII HDDs while
the system is still power-on and in working condition.
eSATAII is equipped with Hot Plug capability that enables you to
exchange drives easily. For example, with eSATAII interface, you may
simply plug your eSATAII devices to the eSATAII ports instead of opening
your chassis to exchange your SATAII hard disk.
2 . 1 2 2 . 1 2 Driver Installation Guide Driver Installation Guide
2 . 1 2 2 . 1 2 Driver Installation Guide 2 . 1 2 Driver Installation Guide Driver Installation Guide
To install the drivers to your system, please insert the support CD to your optical drive
first. Then, the drivers compatible to your system can be auto-detected and listed on
the support CD driver page. Please follow the order from up to bottom side to install
those required drivers. Therefore, the drivers you install can work properly.
ASRock
unctions for SA unctions for SA unctions for SAT T T T T A / SA unctions for SA
AII Devices AII Devices
AII Devices AII Devices
® GeForce 8200 chipset provides hardware
K10N78hSLI-GLAN Motherboard
A / SA A / SA A / SAT T T T T AII A / SA AII AII AII AII
2 5 2 5 2 5
2 5 2 5