ASROCK K10N78hSLI-GLAN Mode D'emploi page 24

1. In order to enable the eSATAII port of the I/O shield, you need to connect the
orange SATAII connector (SATAII_6 (PORT5); see p.2 No.11) and the eSATAII
connector (eSATAII_TOP; see p.2 No.35) with a SATA data cable first.
Connect the SATA data cable
to the orange SATAII
connector
(SATAII_6 (PORT5))
2. Use the eSATAII device cable to connect eSATAII device and the eSATAII port of
the I/O shield according to the eSATAII connector that you connect the SATA
data cable.
Connect one end of the eSATAII
device cable to eSATAII device
2 . 1 0 2 . 1 0 2 . 1 0 Serial A Serial A Serial AT T T T T A (SA Serial A A (SAT T T T T A) / Serial A A (SA A (SA
2 . 1 0 2 . 1 0 Serial A A (SA
Installation Installation Installation Installation Installation
This motherboard adopts NVIDIA
(SATA) / Serial ATAII (SATAII) hard disks and RAID functions. You may install SATA /
SATAII hard disks on this motherboard for internal storage devices. This section will
guide you to install the SATA / SATAII hard disks.
STEP 1: Install the SATA / SATAII hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA / SATAII hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATAII
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA / SATAII hard
disk.
2 4 2 4 2 4
2 4 2 4
ASRock
Connect the SATA
data cable to the
eSATAII connector
(eSATAII_TOP)
Connect the other end of the eSATAII device cable
to eSATAII port of the I/O shield
A) / Serial A A) / Serial AT T T T T AII (SA A) / Serial A AII (SAT T T T T AII) Hard Disks AII (SA AII (SA
A) / Serial A AII (SA
®
GeForce 8200 chipset that supports Serial ATA
K10N78hSLI-GLAN Motherboard
AII) Hard Disks AII) Hard Disks AII) Hard Disks
AII) Hard Disks