Alto Professional Stealth Wireless Expander Pack Guide D'utilisation page 7

Dual Channel Setup
To send stereo signals through the Stealth Wireless transmitter to
1. Connect your mixer's
connect the Stealth Wireless receivers' outputs to your loudspeaker's inputs.
2. Connect your Stealth Wireless Expander Pack receivers outputs to your loudspeakers inputs.
Keep all mixer volume and transmitter Trim controls at a minimum.
3. Power on the Stealth Wireless transmitter and
4. Adjust the transmitter and
5. Set the transmitter to "stereo" and adjust the Trim controls to get a strong signal without clipping.
6. Turn on your loudspeaker, adjust the output level of your mixer, and adjust the Trim controls on
the transmitter to hear the audio signal. If
channel until a clean signal comes through.
This diagram shows the
signal flow from a mixer,
through Stealth Wireless,
to speakers.
Powered
Speaker
main outputs to the input channels
receivers antennas to a vertical position.
Stealth Wireless
Expander
Pack Receivers
Stealth
Wireless
Receivers
Transmitter
4 receivers:
on the Stealth Wireless transmitter, and
receivers. Set their channels to matching numbers.
you hear noise in the
Mixer
7
signal, change to a different
Powered
Speaker