ABAC CHISEL HAMMER Notice D'utilisation page 72

EN
USING THE CHISEL HAMMER
Before operating the equipment, put some oil drops (E) in the air inlet opening (F) or the connector (E) of the
pneumatic tool.
Choose the correct chiesel as needed (fig.2).
Remove the spring retainer (I) to load a chisel (C). Always tighten the spring retainer well before use.
WARNING: Use attachments designed for use with air tools. Do not use damaged attachments.
Depress the trigger (H) to operate. Always hold the hammer firmly during operation to avoid injury.
Rotate clockwise/counterclockwise the (G) knob to set the vibrations speed.
H
F
I
G
Fig.3
MAINTENANCE
Disconnect the air supply during maintenance on the tool.
Regularly clean and dry the filter in the system and the pneumatic tool air inlet opening.
Lubricate any quick-disconnect coupling on the system to prevent jamming.
Drain condensation from air filter and from the compressor on a daily basis.
In order to avoid rust formation and to minimize wear, clean and lubricate the tool after each use.
Check the tool regularly on loose bolts/screws or parts.
In case of power loss: have the tool repaired.
Only trained and qualified engineers are allowed to adjust or repair the tool.
In case the tool is equipped with a silencer, make sure that this silencer is working properly, a damaged silencer has
to be replaced.
The tool should be maintained regularly to minimize the noise emission and occurring vibration.
If you intend not to use the tool for a longer period of time, it has to be oiled. Please fill some droplets of resin and
acid free oil into the air inlet and let the tool run free for a couple of seconds.
Maintain the tool at least yearly.
INTENDED USE
The user or the user's employer shall assess the specific use that can be present as a result of each use.
Never use the tool otherwise than the tool is designed for and as explained in this manual.
Damages as a consequence of not following this manual, or caused by incorrect use or incorrect repairs, will never be
covered by our warranty and we will have no responsibility for it. We reserve the right for technical improvements,
without prior notification.
This air hammer is designed for cutting through rusted metal or bolts and removing mortar from cement blocks or
bricks. NEVER USE in water or with asbestos.
If used otherwise a risk assessment has to be made by the employer/user.
72