Sharp MD-MT80H Mode D'emploi page 135

NO SIGNAL z Poor connection of the digital cable.
z No output signal comes out from the connected
unit to playback.
z The input signal has improper sampling frequency.
NOT PLAY z You tried to play back a track that cannot be
played with this equipment.
z You recorded on a playback-only disc.
PLAY MD
POWER ? z Improper power is being supplied.
PROTECTED z The write protection tab of a MiniDisc is set to the
protected position.
z You tried to record on a playback-only disc.
z Since a track number is currently being located or
SORRY
updated, the unit cannot accept your command.
TEMP OVER z The temperature is too high.
TOC FORM (**) z There is an error in the recording signal.
TOC FULL z There is no space left for recording character in-
formation (track names, disc names, etc.).
Tr. Protect z The track has been protected from being erased. z Edit the track with the device on which it was recorded.
z A disc which contains data other than music was
? DISC
played.
z There is an error in the signal recorded on the disc.
Number or symbol appears in (*) position.
z Connect the digital cable securely.
z If the portable CD player has a function to prevent
sound skips, deactivate it.
z Playback with the connected unit.
z Play back another track.
z Replace it with a recordable disc.
z Use one of the specified power sources.
z Move the write protection tab back to its original posi-
tion.
z Replace it with a recordable MiniDisc.
z Wait for a while and try the operation again.
z Turn off the power, and wait for a while.
z Erase all of the tracks, and then record again.
z Replace it with another recordable disc.
z A disc which contains non-music data cannot be
played.
z Replace it with another recorded disc.
E-40
ENGLISH