Important Safety Instructions For All Battery Packs - DeWalt DCD780 Guide D'utilisation

WARNING: Always wear proper personal hearing
protection that conforms to ANSI S12.6 (S3.19) during
use. Under some conditions and duration of use, noise from this
product may contribute to hearing loss.
CAUTION: When not in use, place tool on its side on a
stable surface where it will not cause a tripping or falling
hazard. Some tools with large battery packs will stand upright on
the battery pack but may be easily knocked over.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
Hz ................. hertz
min ............... minutes
or DC ... direct current
................. Class I Construction
..................... (grounded)
................. Class II Construction
(double insulated)
.../min .......... per minute
BPM ............. beats per minute
IPM ............... impacts per minute
RPM ............. revolutions per
minute
sfpm ............. surface feet
..................... per minute
SPM ............. strokes per minute
Important Safety Instructions for All
Battery Packs
When ordering replacement battery packs, be sure to include the
catalog number and voltage. Consult the chart at the end of this
manual for compatibility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before
using the battery pack and charger, read the safety instructions
below and then follow charging procedures outlined.
• Do not charge or use the battery pack in explosive
• NEVER force the battery pack into the charger. DO NOT
A ......................amperes
W .....................watts
or AC ..........alternating
• Charge the battery packs only in designated D
current
• DO NOT splash or immerse in water or other liquids.
or AC/DC ...alternating
• Do not store or use the tool and battery pack in locations
........................or direct
current
n o ....................no load
speed
n ......................rated
........................speed
.....................earthing
for any reason. If the battery pack case is cracked or damaged,
terminal do not insert into the charger. Do not crush, drop or damage
the battery pack. Do not use a battery pack or charger that has
.....................safety alert
received a sharp blow, been dropped, run over or damaged in
symbol
any way (e.g., pierced with a nail, hit with a hammer, stepped on).
Damaged battery packs should be returned to the service center
for recycling.
pack so that metal objects can contact exposed battery
terminals. For example, do not place the battery pack in aprons,
pockets, tool boxes, product kit boxes, drawers, etc., with loose
nails, screws, keys, etc. Transporting batteries can possibly
cause fires if the battery terminals inadvertently come in
4
READ ALL INSTRUCTIONS
atmospheres, such as in the presence of flammable
liquids, gases or dust. Inserting or removing the battery pack
from the charger may ignite the dust or fumes.
modify the battery pack in any way to fit into a non-
compatible charger as battery pack may rupture causing
serious personal injury. Consult the chart at the end of this
manual for compatibility of batteries and chargers.
where the temperature may reach or exceed 105 °F (40 °C)
(such as outside sheds or metal buildings in summer). For
best life store battery packs in a cool, dry location.
NOTE: Do not store the battery packs in a tool with the
trigger switch locked on. Never tape the trigger switch in
the ON position.
WARNING: Fire hazard. Never attempt to open the battery pack
WARNING: Fire hazard. Do not store or carry the battery
WALT chargers.
E