Proficook PC-GK 1162 Mode D'emploi page 56

two screws. Tilt the device carefully
backwards.
CAUTION: CAUTION: CAUTION: CAUTION:
Keep the transport protection for a
possible further transport!
Assembly of the door handle Assembly of the door handle Assembly of the door handle Assembly of the door handle
Open the appliance door and slightly
•
remove the door rubber seal on the
inner door frame. Note the holes
underneath for the positioning of the
door handle.
Fasten the handle with the enclosed
•
screws and bring the door rubber seal
back to its original position.
Electrical connection Electrical connection
Electrical connection Electrical connection
WARNING: WARNING:
WARNING: WARNING:
The installation to the mains supply
•
must conform to the local standards
and regulations.
Improper connection may cause to an
•
electric shock! electric shock
electric shock electric shock
Do not modify the appliance plug. If
•
the plug does not fit properly to the
outlet, let install a proper outlet by an
authorized specialist.
The accessibility of the power plug
•
must be ensured to disconnect the
appliance from the power supply in
case of emergency.
Make sure that the voltage supply
•
matches the specifications on the
rating label before connecting.
Connect the mains cable to a properly
•
installed and earthed wall outlet.
If the plug after installation is not
•
accessible, a corresponding discon-
nect device must be available to meet
the relevant safety regulations.
Startup / Operation Startup / Operation
Startup / Operation Startup / Operation
Vor der Erstinbetriebnahme Vor der Erstinbetriebnahme Vor der Erstinbetriebnahme Vor der Erstinbetriebnahme
Clean the appliance interior including all
accessory parts. Consider the instruc-
tions which we provide in the chapter
"Cleaning and Maintenance".
Starting the appliance Starting the appliance
Starting the appliance Starting the appliance
Connect the appliance to the power
•
supply.
Set the desired indoor temperature.
•
Read the following sections.
Operation Operation Operation Operation
1 1 1 1
Button (1) (1) for control panel activation and
(1) (1)
temperature display change
56
2 2 2 2 3 3 3 3 4 4 4 4