ION OCTAVE LP Guide D'utilisation page 5

Top Panel
Important: Remove the plastic cartridge cover (needle cover) before operating the turntable.
1. Platter: Place your record here.
2. 45 RPM Adapter Holder: Holds the included 45
RPM adapter. When not using the adapter, please
place it in this holder.
3. Tonearm: The fixed tonearm can be raised and
lowered by hand, or by using the Raise / Lower
Lever.
4. 33 / 45 / 78 Switch: This switch controls the speed
of the turntable platter.
Note: For best results when playing 78 RPM vinyl records, use a 78 stylus (sold
separately). Only use a 78 stylus with 78 RPM vinyl records.
5. Arm Clip: This specially designed arm clip secures the tonearm while at rest or when not
in use. The arm clip has been designed to remain in the up position while unlocked.
6. Raise / Lower Lever: Raises and lowers the tonearm.
7. Transit Screw: This screw secures the turntable during shipment. Before operating the
turntable, turn this screw clockwise (so it lowers). This will allow the turntable to "float."
Rear Panel
1. Line Output: Connect this RCA output to a
receiver, amplifier, or powered speakers.
Note: Octave LP's volume control will not adjust
the volume when the line output is in use.
Warning: The RCA outputs are Line level. Please
only connect these to Line level inputs. You may
damage your receiver if you plug in a Line level
device into a Phono level input.
2. FM Antenna: Adjust this antenna for better FM radio reception.
3. Power Input: The integrated power cable is connected here.
Side Panel
1. Cassette Eject / Fast Forward (FF) Button: Push
this button completely down to eject the tape.
Push the button halfway down to fast forward
through the tape.
2. Cassette Door: Insert a cassette tape here.
1
2
2
1
1
2
7
6
5
4
3
3
5