Fujitsu LifeBook TH700 Mode D'emploi page 123

4
If you wish to create a DAR Disc, use a permanent marker to label a blank disc with your system model and
"Drivers and Applications Restore Disc", or the name of the disc you want to create. The discs will be created
in the order of: DAR Disc, Bootable Disc, Recovery Disc #1, Recovery Disc #2, and Application Disc (if
required). Insert the disc in the DVD drive, then click [OK].
5
Be sure you have inserted the blank disc in the DVD drive, then click [Yes] to create the DAR disc. If you click
[No], you will proceed to the Bootable Disc creation procedure. If you click [Cancel], you will return to the main
menu.
6
After the DAR disc has been created, you will be asked if you would like to create a Bootable Disc. If you do,
first use a permanent marker to label a blank disc with your system model and "Bootable Disc".
7
Insert the blank Bootable Disc in the DVD drive and click [Yes] to create the Bootable Disc. If you click [No], you
will proceed to the Recovery Disc #1 creation procedure. If you click [Cancel], you will return to the main menu.
8
After the Bootable Disc has been created, you will be asked if you would like to create a Recovery Disc #1. If
you do, first use a permanent marker to label a blank disc with your system model and "Recovery Disc #1".
9
Insert the blank Recovery Disc #1 in the DVD drive and click [Yes] to create the first Recovery Disc. If you click
[No], you will proceed to the Recovery Disc #2 creation procedure. If you click [Cancel], you will return to the
main menu.
10
After the Recovery Disc #1 has been created, you will be asked if you would like to create a Recovery Disc #2.
If you do, first use a permanent marker to label a blank disc with your system model and "Recovery Disc #2".
11
Insert the blank Recovery Disc #2 in the DVD drive and click [Yes] to create the second Recovery Disc. If you
click [No], you will proceed (if applicable) to the Application Disc creation procedure. If you click [Cancel], you
will return to the main menu.
A
SEPARATE
APPLICATIONS ON THE
DAR D
THE
12
After the Recovery Disc #2 has been created, you may be asked if you would like to create an Application Disc
(see note in box above). If you do, first use a permanent marker to label a blank disc with your system model
and "Application Disc".
13
Insert the blank Application Disc in the DVD drive and click [Yes] to create the Application Disc. If you click [No],
a message stating "Backup disc was created successfully" will be displayed. Click [OK].
A D
PPLICATION ISC IS CREATED ONLY FOR SYSTEMS WHICH DO NOT BACK UP THE
DAR D . I
ISC F YOUR SYSTEM HAS ALREADY BACKED UP THE APPLICATIONS ON
,
ISC YOU WILL NOT BE PROMPTED TO CREATE ONE
122 - Restoring Your System Image and Software
.