Shutdown And Startup Problems - Fujitsu LifeBook TH700 Mode D'emploi

Problem
The battery seems to 
discharge too quickly
(continued)

Shutdown and Startup Problems

The Suspend/Resume 
button does not work.
The system powers up
and displays power on
information, but fails to
load the operating system.
An error message is dis-
played on the screen dur-
ing the boot sequence.
Possible Cause
You're running an application
that uses a lot of power due to
frequent optical drive access,
or use of a LAN ExpressCard,
WLAN, or Bluetooth device.
The battery was exposed to
high temperatures.
The battery is too hot or too
cold.
Suspend/Resume 
button is disabled.
There may be application
software. conflict
You have a secured system
requiring a password to load
your operating system.
The boot sequence settings
of the setup utility are not
compatible with your configu-
ration.
Internal hard drive was not
detected.
Power On Self Test (POST)
has detected a problem.
112 - Troubleshooting
Possible Solutions
Use a power adapter for this application when at all possible.
Replace the battery.
Restore the Tablet PC to normal operating temperature.
Charging icon on the Status Indicator panel will flash when
battery is outside of operating range.
To enable the button, go to the Control Panel -> Power
Options and click on the Advanced tab. In the Power buttons
area, select the "Change what the power button does" option.
Close all applications and try the button again.
Make sure you have the right password. Enter the setup util-
ity and verify the Security settings and modify them as
accordingly. See "BIOS Setup Utility" on page 71.
Set the operating source by pressing the [ESC] key while the
Fujitsu logo is on screen or use the [F2] key and enter the
setup utility and adjust the source settings from the Boot
menu. See "BIOS Setup Utility" on page 71.
Use the BIOS setup utility to try to auto detect the internal
hard drive.
See the Power On Self Test (POST) messages to determine
the meaning and severity of the problem. Not all messages
are errors; some are simply status indicators. See "Power On
Self Test Messages" on page 116.