Tap Equipment And Assembly - Marvel ML24BN Instructions D'installation, D'utilisation Et D'entretien

This beer dispensing unit will support one half (
or one quarter ( ⁄ ) barrel. The double draft tower units can
1
4
support two sixth ( ⁄ ) barrels of beer. See chart below for
1
6
quantity of beer in each barrel size.
1/6 barrel
23 ⁄ "
5
16
Height
(59.2 cm)
9 ⁄ "
1
4
Diameter
(23.5 cm)
Gallons
5.23
#12 ounce
55
Glasses
Keg Size
5 gallon Corny
1/6 barrel
1/4 Barrel
1/2 Barrel
Table D

Tap Equipment and Assembly

Your dispensing kit includes the following parts:
Polished stainless steel tower with clear beer line (single
or double dispense)
Tower Gasket
Phillips oval head screws
Knob for Tower (Faucet Handle)
Keg coupler(s)
Gas regulator with red gas line(s) attached
Empty 5 pound gas tank
Plastic clamp(s) large and small
Faucet wrench
USING YOUR BEVERAGE DISPENSER
⁄ ) barrel
1
2
Barrel Sizes
1/4 Barrel 1/2 Barrel
14 ⁄ " 23 ⁄
13 5
16
(37.6 cm) (59.2 cm)
17" 17" to 17
(43.2 cm) (43.2 to 43 cm)
7.75 15.5
82 165
Table C
#of kegs per
5 pound gas Tank
15 to 22
14 to 21
10 to 14
5 to 7
Tools required for installation:
Flat bladed screwdriver
Phillips screwdriver
Pliers
Adjustable wrench or a 1
⁄ " open end wrench
1
2
"
16
⁄ "
1
4
Gas can be dangerous. If it becomes difficult to
breathe and/or your head starts to ache, a high
concentration of carbon dioxide may be present.
Leave the area immediately.
• The gas tank must always be connected to the
regulator. Never connect the tank to the keg.
• The gas tank must be securely mounted in the
upright position. Secure it with the chain pro-
vided.
• Never drop or throw the gas tank.
• Keep the gas tank away from heat.
• Ventilate the area after a gas leak.
1. Remove shelving and packaged components from
the interior of the refrigerator before beginning the
assembly process.
2. Take your empty 5 pound gas tank to your local gas
supply dealer to be filled. You can usually find them in
your "yellow pages" under "Welding Supply" or "Fire
Protection". One 5 pound tank can process many kegs
(see table "D").
3. Tower Mounting: DO NOT REMOVE INSULATION
INSIDE OF STAINLESS STEEL TOWER. INSULATION
KEEPS BEER IN CLEAR LINE COLD AND FRESH.
Mounting Tower to Refrigerator Top: Remove the
foam plug from the porthole and DO NOT reseal.
Clearance in porthole is necessary for cold air to flow
into the tower and keep the beer line cold.
Mounting Tower to Counter Top: Remove the foam
plug from the porthole and use to "bridge" the gap
between the top of the cabinet and the underside of the
counter. Leave adequate clearance for cold air to flow
into the tower and keep the beer line cold.
18
⁄ " open end wrench
1
8
WARNING
!