Using Your Beverage Dispenser; Shelving - Marvel ML24BN Instructions D'installation, D'utilisation Et D'entretien

Shelving

The unit is shipped with the (2) shelves taped in place in
the upper and the lower shelf positions. Remove them from
the refrigerator and arrange them as follows when setting
up your unit.
Figure 23
If you are not serving beverages on tap, your keg dispenser
can be used as a refrigerator by placing both shelves on
the mounting brackets as shown in Figure 22. The shelves
are marked upper and lower, The upper shelf should be
placed in the top shelf position and the shelf marked lower
should be placed in the bottom shelf position.
CAUTION
!
If you are using the appliance as a refrigerator for per-
ishable foods, the set-point temperature should be set
between 34°F and 42° F (1.2° C and 5.7° C).

USING YOUR BEVERAGE DISPENSER

Two shelves
Two shelves
installed
Figure 24
If you are using a quarter barrel of beer, you can add shelf
space for keeping your mugs chilled. The quarter barrel
must set on the floor, it cannot fit on the shelf, see
Figure 25. Be sure the white floor plate is in the bottom of
the interior compartment before positioning the barrel.
Quarter barrel
Figure 25
If you are using a half barrel (keg) or (2) 1/6 barrels, place
the two shelves on the right side of the keg dispenser on
the two mounting hooks for storage. (See Figure 26). Be
sure the white floor plate is in the bottom of the interior
compartment before positioning the barrel(s).
Half barrel (keg)
17
Installed upper
shelf above
barrel
Stored lower shelf
White floor plate
Stored upper and
lower shelves
on side
White floor plate
Figure 26