Reiner P3-MP Mode D'emploi page 10

1. Making the print head ready for use
1.1. Opening the pack  Fig.
Cut open foil pouch
f
Remove printing cartridge
f
1.2. Releasing the clip  Fig.
The print cartridge
Slightly push apart the latching wings
f
Remove safety band
f
Remove printing cartridge.
f
Use the printing cartridge according to the operating
f
instructions for the device.
2. Printing material
For the best results, use material that is clean, non-greasy, dry
and at the same temperature as the print head.
Polar or polarised surfaces are better suitable on plastics to be
printed on than surfaces with unpolar properties.
Before carrying out a large print job, perform a test print.
9
A
1
with shears.
2
.
B
2
is supplied with a reusable dust cover
4
.
C
+
5
.
3
.