Bosch PWS 20-230 Instructions D'emploi page 11

1 609 929 R44 - Buch Seite 1 Dienstag, 11. März 2008 2:06 14
Tool Specifications
Angle Grinder
Order number
With residual current-limit control
Order number
Rated input power*
Output power
No-load speed
Grinding disc dia. max.
Grinder spindle thread
Weight without cable, approx.
Protection class
* The values given are valid for nominal voltages [U] of 230/240 V. For lower voltages and models for specific countries,
these values can vary.
Please observe the order number of your machine. The trade names of the individual machines may vary.
Inrush currents cause short-time voltage drops. Under unfavourable power supply conditions, other equipment may be
affected. If the system impedance of the power supply is lower than 0.25 Ohm, disturbances are unlikely to occur.
Machine Elements
The numbering of the device elements refers to the illustration of the machine on the graphics page.
1 Thread for auxiliary handle (3x)
2 Spindle lock button
3 On/Off switch
4 Auxiliary handle
5 Grinder spindle
6 Protection guard
7 Clamping screw
8 Coded projection
9 Mounting flange with O-ring
10 Grinding/cutting disc*
11 Clamping nut
12 quick-clamping nut*
13 Adjustment screw
* Not all of the accessories illustrated or described are included as standard delivery.
Intended Use
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is re-
quired.
11 • 1 609 929 R44 • 05.01
PWS 20-230
0 603 359 0..
0 603 359 6..
PWS 20-230 J
0 603 359 9..
[W] 2 000
[W] 1 250
[rpm] 6 500
[mm] 230
M 14
[kg] 4.2
/ II
14 Clamping lever
15 Guard, grinding cup*
16 Grinding cup*
17 Two-pin spanner for clamping nut *
18 Hand guard*
19 Spacer discs*
20 Rubber sanding plate*
21 Sanding sheet*
22 Round nut*
23 Cup brush*
24 Cutting guide with dust extraction protection
guard*
25 Diamond cutting disc*
26 Cutting grinder stand*
Noise/Vibration Information
Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the ma-
chine are: Sound pressure level: 90 dB (A);
sound power level: 103 dB (A).
Wear hearing protection!
The weighted maximum acceleration is typically
2
5.5 m/s .
When using the vibration-dampening auxiliary
handle, the hand-arm vibration at the auxiliary
handle is typically below 2.5 m/s
English - 1
PWS 1900
0 603 359 02.
1 900
1 170
6 500
230
M 14
4.2
/ II
2
.