Christopeit Sport BT4 Notice De Montage Et D'utilisation page 20

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check that all are there on the basis of the step drawings in these
instructions for assembly and use. Please note that a number of parts
have been connected directly to the main frame and preassembled.
In addition, there are several other individual parts that have been at-
tached to separate units. This will make it easier and quicker for you
to assemble the equipment. Assembly time: 30 - 40 min.
Step 1:
Attach the stabilizer (2+3) at main frame (1).
1. Attach the front foot (2) with the preassembled transport rollers (10)
to the main frame (1). Do this with the two screws M8x75 (5), washers
8//25 (6), spring washers M8 (24) and cap nuts M8 (7).
2. Attach the rear foot (3) to the main frame (1). Do this with the two screws
(5), washers (6), spring washers (24) and cap nuts (7). After assembly
has been completed, you can compensate for minor irregularities in
the floor by turning the adjusting end cap (4). The equipment should
be set up that the equipment does not move of its own accord during
a training session.
Step 2:
Attach the pedals (9R+9L) at pedal crank (8).
1. Attach the pedal straps to the appropriate pedals (9R+9L).
NOTE: The end with many adjustable holes must be set outwards.
2. The pedals (9R+9L) are marked with „R" & „L"
NOTE: Right and Left is specified as viewed seated on the machine
during training.
Connect each pedal (9R+9L) to the matching pedal crank (8R+8L)
(NOTE: The right pedal „R" should be threaded on clockwise. The left
pedal „L" should be threaded on counter-clockwise.)
20