Troubleshooting - Trotec UV-TorchLight 15F Manuel D'utilisation

Charging the 18650 li-ion batteries with the CH-01
charger included in the scope of delivery:
The rechargeable battery can be replaced regardless of
its charge state. Place the rechargeable battery in the
CH-01 charger and ensure that the positive pole is posi-
tioned in the direction of the LED. The LED remains red
until the battery is fully charged. The green LED lights up
when the battery is fully charged.
Take the rechargeable battery out of the charger and
disconnect the charger from the mains power supply.
Only charge 18650 / LRB-168A li-ion rechargeable bat-
teries with battery overvoltage protection in the CH-01
charger!
The rechargeable battery included in the scope of deli-
very is pre charged.
The charging cycle lasts a maximum of 3.5 hours.
If you are planning on not using the battery for longer
than 2 months, charge the battery to its full capacity
before storing.
EN

06. Troubleshooting

Problem
Light of the
torch does not
go on
Solution
If the torch light goes on when the negative pole of the
rechargeable battery / the rear battery is connected to
the bare aluminium of the torch with a paper clip, for
example, then the switch on the tailcap is defective.
This is a spare part and can be ordered separately.
If your torch still fails to work, please contact our Service
Hotline on +49 2452 962-450.
Operating Manual – High Performance UV Torch
Possible cause
Is the positive pole of the rechar-
geable battery / batteries facing
towards the head of the torch?
Rechargeable battery / batteries full?
Is the tailcap screwed firmly on to
the battery housing?
B - 6