Getting Started - Trotec UV-TorchLight 15F Manuel D'utilisation

05. Getting Started

Inserting the rechargeable battery
Unscrew the tailcap
2
li-ion rechargeable battery or the 2 CR123A batteries in-
cluded in the scope of delivery. Screw the tailcap back on.
Switching on/off
Momentary light: Press switch
Continuous light: Press switch
again to power off.
Adjusting the Focus:
B - 5
of the torch and insert the 18650
A
gently.
A
hard. Press the switch
Operating Manual – High Performance UV Torch
The focus of the light beam can be adjusted by turning
the head of the torch
the torch when the torch is under water as this would
allow water to enter the housing! Insert the battery in-
cluded in the scope of delivery and switch on the torch
to ensure that it is working properly. Direct the beam of
the lamp at a banknote, for example, or any other object
which is known to contain UV active substances, from a
distance of approximately 1 m. The active substances
will become immediately visible if the torch is working
properly.
Next check the focus of the torch by adjusting the fo-
cus from minimum to maximum. The beam of the light
should change from a pinpoint beam to a broad beam
and vice versa. Repeat this procedure with a variety
of different objects at a distance of approximately 1m
in order to gain a feeling for the way the beam can be
adjusted. Generally speaking, the illuminated area be-
comes smaller the more focused the beam is, which in
turn means that fluorescent traces can be detected over
greater distances because the beam is so intense. In
contrast, a broad beam can illuminate a larger area, but
does not allow you to detect objects or traces which are
further away from the torch.
. Do NOT adjust the focus of
1
EN