Horizont insect-o-kill 30plus Notice D'utilisation page 6

2. Unpacking the unit
Each unit is carefully packed before leaving the production factory to
ensure it reaches you in perfect working order.
Please be sure to remove all packing from the unit before installation.
3. Locating the unit
The attraction of the insect-o-kill unit to flying insects is partly dependent
on the intensity of competing daylight or artificial light. The correct sigh-
ting of the unit is therefore most important in order to achieve the maxi-
mum of efficiency. The unit should be operated day and night when flying
insects are prevalent. Where possible, follow these guidelines:
• Mount the unit above head-height and preferably, above arm's reach.
• To comply with current health and safety legislation for working at
heights ensure that safe and appropriate access to the unit for main-
tenance and cleaning is available.
• Place the unit as far as possible from windows to minimize competition
from sunlight.
• Do not place the unit directly over exposed foods, food preparation surfa-
ces or packing lines.
• Do not hang the unit over sources or heat or steam since this may dama-
ge the insulation of the electric cables.
• Place the unit out of reach of children.
• The unit can be mounted on a flat table/shelf surface.
• Ensure a suitable power supply is located close by the intended position.
4.Assembly & Installation
Decide which method of installation and follow the instructions as follows:
Wall-Mounted Mode
Identify a suitable location for mounting your unit, as instructed in section
3. Drill 2 holes 38cm (15 inch) apart suitable for No. 8 plugs. Insert the two
plugs provided and screw in the two No. 8 screws to within 5mm of the
surface.
Hang the unit on the screws taking care to make sure the screws are inser-
ted fully into the unit and are not just
resting on the plastic cover.
Suspended Mode
Fit the two hanging tabs to the top cover and secure with the two screws
provided. Do not overtighten the srews.
6