F.F. Group SPP 800X Notice Originale page 4

4 | English
ENGLISH
SAFETY MEASURES
Read carefully the operating instructions
before assembling and starting. The appli-
ance must not be used by operators who
are not thoroughly acquainted with the
instructions handbook (operating instruc-
tions). Moreover, the appliance must not be
used by persons under the age of 16.
The user is liable towards third parties in the area
f
where the appliance is in operation.
Before starting it is necessary to check that the nec-
f
essary electrical protection measures are met, by
means of a test carried out by a specialist.
While the pump is operating, no person
should be in the liquid. The pump may be
connected only by means of a safety switch
for fault currents, with an opening rated
current up to 30 mA and a socket with an
earth contact in compliance with the reg-
ulations.
Protection: at least 10 Amps.
Operation in swimming pools and garden
ponds is not recommended.
CAUTION: Before checking, unplug the
pump from the mains!
Replacing the power supply cable requires using
special tools and therefore you must address to
the authorized after-sales service.
The pump may only operate with an extension ob-
tained through cable mod. H07 RNF and a thread
section of no less than 1 mm in compliance with
the DIN 57282 or DIN 57245 standard.
The noise (continuous equivalent in dbA) of the mo-
f
tor-driven pumps is less or equal (≤) to 85 dbA.
The voltage (230 Volts alternating current) indicated
f
on the pump rating plate must correspond to the
available mains voltage.
The temperature of the liquid conveyed must not
f
exceed 35 C.
ο
Never attempt to lift or move the pump by stretch-
f
ing the power-supply cable whilst it is plugged into
the mains.
Make sure that the plugged electrical connections
f
are in an area safe from flooding and are protected
from humidity.
Before use it is necessary to check that the plug and
f
the mains connection line are not damaged.
Unplug from the mains before performing any work
f
on the pump.
Avoid directly exposing the pump to the jet of water.
f
The user is responsible for complying with the local
f
regulations concerning assembly and safety.
The user by taking appropriate measures (e.g. install-
f
ing an alarm, reserve pump and the like) will have to
exclude the possibility of indirect damage caused by
flooding premises due to failure of the pump.
SPP 800X - SPP 1200X - SPP 800
In the event of the pump failing, repair work may
f
only be carried out by the repair workshops of the
authorized service. Only genuine spare parts must
be used.
It is notified that in conformity with the law on prod-
f
uct liability we cannot be held responsible for the
damage caused by our appliance:
1. Because of improper repairs not carried out by
the personnel of the assistance points autho-
rized by us; or
2. If GENUINE SPARE PARTS are not used to re-
place parts; or
3. If the indications and provisions given in the
instructions handbook are not complied with.
The same provisions hold for the accessories.
RESISTANCE
This pump should not be used to convey inflam-
mable, combustible or explosive liquids.
TECHNICAL DATA
Article Number
Model
V
Voltage /
Frequence
Hz
Rated Power W
Max. height m
Max.
L/h
flow rate
Max.suction
m
height
Max. Grain
mm
Size
Diameter of
Connecting
Pipe
Max.
bar
Pressure
Max. Noise dB
Max.media
C
o
temperature
Cable Lenght m
Weight kg
Protection
Insulation
Class
43 483 43 484 43 485
SPP SPP SPP
800X 1200X 800
230 230 230
50 50 50
800 1200 800
38 46 38
3200 3700 3500
8 8 8
1 1 1
1" 1" 1"
3,8 4,6 3,8
85 85 85
35 35 35
1 1 1
6,4 7,7 6,4
IPX4 IPX4 IPX4
B B B