Franke FIRECLAY Manuel D'installation page 10

EN
2. Measure the Sink
1. The cut-out opening for the sink
will be determined by establishing
dimensions L and W. These dimensions
are measured from the centre of the
sink rim (which should also be the high
point of the sink rim).
2. Dimension W is measured from the
centre of the sink rim on either side of
the basin.
3. Dimension L is measured from the
centre of the back rim to the start of
the radius on the apron of the sink (the
intent is to position the sink so that the
start of the apron radius aligns with the
front face of adjacent cabinetry).
3I
L
3J
R
W
3. Prepare the Countertop
1. Transfer dimension W to the
countertop such that the sink is
positioned laterally within the sink base
cabinet unit.
2. Transfer dimension L to the
countertop. Then add the countertop
front overhang to this dimension.
3. Scribe a desired radius in the two
back corners of the cut-out.
4. Cut-out the sink opening.
3K
L
O
Top view
3L
O
Side view
F
- Front of base cabinetry.
O
- Overhang distance
R
- Radius on the apron of the sink
– 10 –
W
L
F
L
F