Brandt VF200JU1 Notice D'utilisation page 6

Operation
The control band in the upper section of the door is visible on opening.
Press the ON button to start the machine
The meaning of the symbols is listed on the sticker attached in the document folder. If you
wish, stick it to your machine's door.
1 - Load the dishwasher, check that the dishes
do not obstruct the turning sprinkler arms.
2 - Introduce dishwashing product.
3 - Press the "On/Off" button to switch
on the dishwasher. The "On" light will go on.
4 - Select the programme by pressing the
required button.
5 - Open the water supply tap.
6 - Press the "Start" button, the
"Washing on" light will go on. The
programme begin when you close the
door.
Take care not to press 2 or 3 wash-
programme keys at the same time.
If you make a wrong selection, simply press
the same key again to release it.
When the programme has ended, the
"Washing on" light will go out.
If the "on/off" light it on, it shows that the
machine is switched on.
For best results, do not open the door once the
programme has started.
8
The missing product indicator
lights
go on when the machine is turned on.
Salt:
lights up when salt is low. After you
have added regenerating salt it may stay on
until the salt has dissolved sufficiently. This
happens generally after a cycle (or if you have
not properly filled the machine – see page 4)
for example when starting off with the sample.
Note: where water is particularly soft
regenerating salt is not needed but the light
will remain on.
Rinsing product:
Goes on, door ajar,
when you should add rinsing product (see
filling page 5)
Economical and ecological
washing
Do not pre-wash your dishes by hand.
Use all the capacities of your dishwasher. It will
wash economically and ecologically.
To obtain optimum washing results it is very
important to adjust the salt and rinse aid levels
in your dishwasher according to the level of
water hardness as detailed on pages 4 & 5.
Always choose the programme best adapted to
the stains and the type of dishes.
Avoid using too much detergent, regenerating
salt and rinsing liquid. Observe the
recommendations contained in this manual
(pages 5, 6 and 7) as well as the product
manufacturer's instructions.
GB
Cleaning and maintenance instructions
• Your dishwasher comes with a self-cleaning
pulse filter that constantly filters small
particles of dirt trapped in the washing bath.
The filter and the main filter cannot be
dismantled as the cleaning arm constantly
cleans them.
Nevertheless:
- regularly clean the waste trap. To do this:
➀ ➀
Fig. 12 Pull the waste trap handle upwards.
- clean the drainage outlet (3 to 4 times per
annum). To do this:
➁ ➁
Fig. 12 Remove the drainage outlet by
pushing the tab backwards, and then pulling
upwards.
- Remove residue using a brush.
- Clean under running water.
- Return the unit to its housing taking care that
it is well engaged.
Clean as necessary
• Underneath the filters, around the door and
the door joint with a damp sponge to remove
any deposit.
• Use only soap and water for the bodywork
and control board.
Information for test laboratories
Comparative tests according to FIG. 10 - 11
• Rinsing product set at 2
• Capacity 12 place settings
• Upper basket:Setting the LOW POSITION
• Quality of washing product : 30 g product B
- It is essential that the softener be adjusted to a setting immediately above the recommended one,
according to the hardness of your water, to take into account the lack of phosphate in the
standardised detergent.
- Should deviations exist compared with EN0242 comparative tests regarding the degree of soiling,
the type of dishes and cutlery etc..., contact the manufacturer of the equipment before starting
tests.
IEC 436, DIN 44990 : "Normal wash Programme"
EN 50242: "Fragile wash Programme
Do not clean with abrasive powders,
scouring pads, spirit-based products or
solvent.
Use preferably a cloth or a sponge.
• If you have stainless steel door you may use
products adapted for stainless steel. See the
manufacturer's instructions for advice on their
use.
Every year
To maintain your machine in perfect working
order you should clean it once or twice a year.
Run an intensive programme with the machine
empty and a special dishwasher cleaning
product available from any reputable dealer.
Prolonged period of non-use
Clean your machine completely then unplug
the electricity supply and close the water tap.
Keep the appliance at a temperature above
freezing.
"
GB
9