Witter AL9U Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar
B 2 Bracket
C 2 Drill template / Spreader Plate
D 6 M8 Nyloc Nuts and Plain Washers
E 4 M12 x 35 x 1.75p Bolts, Lock Washers
F 2 M12 x 35 x 1.75p Bolts, Lock Washers and Flat Washers (25mm Diameter)
G 1 Safety Chain Attachment
ZE 1 Retractable Electrical
ZN 1 3025 series Neck Kit
FITTING
1. Remove each rear light cluster (1 screw on boot face and pull rearwards)
2. Remove bumper. (1 screw at each tip, 3 screws in wheel arch, 4 screws along bottom edge, 1 top edge at corner of boot
opening. Pull rearwards to unclip.)
3. Remove bumper beam.
4. Place drilling templates (C) centrally on the bottom face of each chassis rail, slide to the rearmost end of the rail until it
touches the rear panel and use to mark hole positions on the face of the chassis rail
5. Drill marked holes ∅13 through bottom face of chassis rail only, and seal with suitable rust preventative.
6. Insert Brackets (B) into chassis rails and loosely secure with fasteners (E) and Spreader plates (C) to bottom face of
chassis rail.
7. Loosely attach Cross Bar (A) to rear panel of car using fasteners (D) and to Brackets (B) using fasteners (F).
8. Attach the chosen Neck Kit (ZN), Electrical Plate Kit (ZE) and Safety Chain Attachment (G) to Cross Bar (A) using
separate fasteners and instructions from the Neck and Electrical Plate kits.
9. Fully tighten all fasteners.
10. Cut bumper as shown below (hatched area) and refit to vehicle.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
For Alfa Romeo Giulietta 2010-
# N A M E ?
W0001AL9U-FIT$011003250000
TOWBAR
AL9U
For use
with 3025
series
necks