Westfalia 306324600001 Mode D'emploi page 2

SIARR
06 - 105
PREPARATION
* Remove the central part of the bumper.
* Remover the bumper support.
ASSEMBLY
* Fasten the tow bar crosspiece on to the vehicle
(without tightening) using fastening kit W.
* Fasten the right and left arms (without tightening) using fastening
kits Y and Z (the 6mm thick back plate is located on the floor).
FINISHING
* Tighten all of the nuts, screws and bolts to the torques indicated below.
* Make a cut in the bumper as per the diagram opposite.
* Replace the bumper.
FASTENING KIT
4 off HM16x45 screws
X
4 off HM16 nuts
4 off DEC16 washers
2 off HM10x100 screws
2 off HM10 nuts
2 off DEC10 washers
Y
2 off 10/22 washers
2 off spacers dia. 12/17 lg.74mm
2 off back plates thick6mm
M16 AC8.8 19,5daNm M12
M16 AC10.9 27,5daNm M10
M12 AC8.8 8,1daNm M10
ASSEMBLY INSTRUCTIONS
4 off HM8x40 screws
Z
4 off 8/27 washers
4 off DEC8 washers
2 off HM8x40 screws
W
2 off 8/27 washers
2 off DEC8 washers
TORQUES :
AC10.9 11,4daNm M8 AC8.8
AC8.8 4,7daNm M8 AC10.9
AC10.9 6,7daNm
FILE : BUREAU\NOTICEDEMONTAGE\SIARR\NDMWESTFALIA\NDM06105-G - FOLIO NDMANG
Type Type
Approval No.
Tow bar for
FIAT e11*94/20*00*3776
Doblo
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
306324600001
Max. Total Max. Total Max. Verti-
Authori. Weight Towable Weight
cal load
2 100 kg 1 100 kg
Value
D
60 kg 7,08 kN