Dometic GROUP WAECO PerfectView M55L Instructions De Montage page 34

Using the LCD monitor
8.3 Setting the monitor
To set the monitor to suit your requirements, proceed as follows (fig. 0, page 6):
➤ Press the "
✓ The parameters to be set appear in the following order:
Page 1: Picture
– Brightness: 0 – 100
– Contrast: 0 – 100
– Colour: 0 – 100
– Volume: 0 – 100
– Auto Dim On, Off
Page 2: Options
– Language: German, English, French, Italian, Dutch, Spanish, Portuguese, Russian
– Camera 1/Camera 2/Camera 3: Normal or Mirrored
– Sensitivity: 1, 2
Setting of the switching threshold for the night dimmer function to avoid glare.
In dimming mode, the switching threshold can be set at two levels.
Page 3: Default
– Reset ("Default"): Default setting for all parameters
➤ Press the "+" button (3) or the "–" button (4) to set the required parameter.
➤ Press the "+" button (3) to increase the value of the selected parameter.
➤ Press the "–" button (4) to reduce the value of the selected parameter.
8.4 Setting the video source
Proceed as follows to set the video source (fig. 0, page 6):
➤ If you would like to switch to a different video source, press the "CAM" button (6).
✓ The monitor changes the camera in the order "Camera 1 – Camera 2 – Camera 3".
8.5 Detecting the trailer camera
This function is required when using a trailer camera (fig. c, page 7) if the system is
activated automatically via the reverse gear.
 One camera connected (e.g. vehicle without a trailer):
the camera connected to CAM1 (1) is activated.
 Two cameras connected (e.g. vehicle with a trailer):
the camera connected to CAM3 (2) is activated (CAM1 is inactive; CAM1 can only be
activated via the "CAM" button)
34
" button (5) to call up the required parameter.
PerfectView M55L, M75L
EN