Publicité
GB
F
D
E
FEATURES
KNOW YOUR SCREWDRIVER
Fig.1
A. ON / OFF SWITCH
B. TORQUE ADJUSTMENT CAP
C. COLLET
D. CLUTCH CAP COVER
OPERATING INSTRUCTIONS
CHARGING YOUR SCREWDRIVER
Fig. 2
A. CHARGER
B. CHARGE INDICATOR LIGHT (LED)
C. CHARGER PLUG
D. INPUT JACK
This tool has been shipped in low charge condition to
prevent possible problems. Therefore, you should charge
it overnight prior to use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (drilling followed
by re-charging) for them to become fully charged.
Note: Only use the charger provided.
Connect charger to the tool by inserting charger plug
into input jack. Make sure the power supply is normal
household voltage, 230V, 50Hz, AC only.
Connect charger to power supply.
The charge indicator light (LED) will light up when
charger is properly connected power supply.
After normal usage, a minimum charge time of
3-5 hours is required to recharge a completely
discharged battery.
The charger housing and the tool handle will become
slightly warm to the touch while charging. This is
normal and does not indicate a problem.
DO NOT operate driver while it is connected to the
charger. The driving ability will not increase.
DO NOT place charger in an area of extreme heat
of cold. It works best at normal room temperature.
TORQUE ADJUSTMENT
Fig. 3
A. TO DECREASE TORQUE
B. TO INCREASE TORQUE
C. TORQUE ADJUSTMENT RING
The torque is adjusted by rotating the torque adjustment ring.
I
P
NL
S
DK
English
The torque is greater when the torque adjustment ring is
set on higher setting and less when set on a lower.
Rotate the adjustment ring to the desired setting.
ON / OFF SWITCH
Fig. 4
A. ON/OFF SWITCH
CHANGING DRIVER ROTATION
Fig. 5
A. UP (FORWARD)
B. DOWN (REVERSE)
REMOVING BATTERIES
Fig. 6
A. HANDLE HOUSING
B. GEAR BOX HOUSING
To remove the batteries ensure that your driver is
disconnected from the charger.
OPERATING INSTRUCTIONS
BATTERY DISPOSAL
To preserve natural resources please recycle or dispose
of the battery properly.
7
N
FIN
GR
H
CZ
Depress to start and release to stop your driver.
To insert a screw, depress the up arrow.
To remove a screw, depress the down arrow.
Drive out the four screws that connect the gearbox
housing and handle housing and pull off the gear box.
Loosen the two screws that connect the handle to the
motor housing.
Loosen the three screws holding the handle housing.
Open the handle and take out the battery for disposal.
WARNING
Upon removal, cover the battery terminals with
heavy duty adhesive tape. Do not attempt to
destroy or disassemble batteries or remove any of
its components. Nickel-cadmium bat ter ies must
be recycled or disposed of properly. Also never
touch both terminals with metal objects and/or
body parts as short circuit may result. Keep away
from children. Failure to comply with these
warnings could result in fire and/or serious injury.
RUS
RO
PL
Publicité
