Recipe Database; Load Recipe (From Database); Search Recipe - BEHAbelt PPuls HP01 Mode D'emploi

displayed value, use key [6]
enter a new value with the numerical keys.
Enter desired welding temperature (from 0°C to 300°C). Confirm entry with key
also cancel the entire entry by pressing key [5]
When the entry of the temperature of the upper heating platen is completed the temperature
of the lower heating platen starts flashing. Enter this value accordingly. After having pressed
key [6] Confirmation/OK
format h/m/s separately for hours, minutes, and seconds). To save the values, press key [6]
Confirmation/OK
display continues to show the entered values for control purposes, however, without the fields
flashing.
By pressing key [6] Confirmation/OK
the system switches back to stand-by mode; the values are saved.
By pressing key [5] Exit/Cancel
where the cursor was positioned is not changed, and the previous values are accepted even if
these were changed.
4

Recipe database

Open recipe database with key [2]
contains the temperature settings for the upper and the lower heating platens as well as the
dwell time. The settings of further temperature steps, if any, are also saved. An individual
recipe can be saved for each type of belt.
4.1 Load recipe
Press key [2]
recipe and confirm with key Confirm/OK
sure that you use the correct recipe. By pressing key [6] Confirm/OK
values and exit the recipe database. To exit press key [5] Exit/Cancel
return to selection.
4.2 Search recipe (limit selection)
If there are many recipes in the database, it may be easier to search for the desired recipe.
Press key [2]
activate the search function. The cursor on the first position of the recipe text is flashing. Use
the keypad to enter a new letter or a number. All recipes with a matching value at this position
will be included in the list. The number of recipes that were identified is shown at the upper
right on the display.
to accept this value and to move to the next field or directly
the dwell time starts flashing. Enter dwell time (for display
. The entry mode ends automatically when the last field is confirmed. The
long, the entry mode can be exited early. The value,
to open recipe database. Use arrow keys Up
briefly to open recipe database. Now press key [2]
long.
once again or by pressing key [5] Exit/Cancel
. A maximum of 200 recipes can be saved. Each recipe
. The welding parameters are displayed. Make
. You can
/ Down to select a
you accept these
. In this case you will
again briefly, to
41