Removing The Vacuum Chamber; Replacing The Vacuum Chamber; Troubleshooting - Buffalo S097 Mode D'emploi

Telephone Helpline: 0845 146 2887 (United Kingdom)

Removing the Vacuum Chamber

Pull the chamber release lever.
1.
Lift the vacuum chamber and remove it from the
2.
appliance.

Replacing the Vacuum Chamber

Slot the right end of the chamber into the
1.
recess.
Ensure the suction nozzle (A) connects securely
2.
with the vacuum chamber, and the positioning
knob (B) sits securely in its seat.
Press the left side of the chamber down until the
3.
release lever clicks back into place.

Troubleshooting

Fault
The unit is not working
Appliance does not remove all
the air from the bag
Bags are not sealing correctly
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Open end of bag not
completely inserted
Gaskets dirty
Open end of bag is dirty
Bag may be punctured
Incorrect bags used
Sealing bar is overheating
Incorrect bags used
Action
Check the unit is plugged in correctly
and switched on
Call BUFFALO agent or qualified
technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified
technician
Open lid and reposition bag
Clean gaskets
Clean bag
Line bag with paper towels to protect
against foodstuffs with sharp edges
Replace bag
Call Vacuum Pack machine supplier
Open lid and allow sealing bar to cool
down
Call Vacuum Pack machine supplier
UK
4